Senior-Internal-Corrosion-Technologist Premium Exam Engine – Download Free PDF Questions [Q27-Q45]

NEW QUESTION 27
NACE No. 13/ SSPC 6 Identifies the use of:

NEW QUESTION 28
Examples of non-ferrous metals include
Select All that Apply:

NEW QUESTION 29
The cost of qualified Coating Inspection Is normally offset by:

NEW QUESTION 30
On pipelines, which coating is Identifiable by Its distinct colors, usually light blue, green, or grey?

NEW QUESTION 31
The HATE adhesion tester uses

NEW QUESTION 32
Which concrete smoothing technique Involves scrubbing a mixture of cement mortal over the concrete surface using a cement sack, gunny sack, or sponge rubber float?

NEW QUESTION 33
In the event of a conflict between the Product Data Sheet and the Specification:

NEW QUESTION 34
The main reason dehumidification Is used during coating operations is to

NEW QUESTION 35
Coating Surveys are legally required:

NEW QUESTION 36
When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

NEW QUESTION 37
You are the new NACE Level 2 Inspector on a Job which had been very problematic. The previous Inspector was fired due to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you In no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action Is to:

NEW QUESTION 38
When using a destructive Paint Inspection Gauge the NACE inspector must:

NEW QUESTION 39
When measuring the Dry Film Thickness of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument Is the:

NEW QUESTION 40
The best choice of Instrument for holiday testing of thick film concrete coatings is:

NEW QUESTION 41
You are the NACE Coating Inspector ona tank lining project where desiccant dehumidificationis being used.
Since the first shift ofabrasive Wasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

NEW QUESTION 42
Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

NEW QUESTION 43
The Inspectors’ goal at the Pre-Job Conference is to:

NEW QUESTION 44
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness Is approximately 10 mils, the Inspector should use:

NEW QUESTION 45
You are theNACE Coating Inspector on a tank lining project and are asked to perform ahigh voltage holiday test after thecoating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course or action should be to: