100% Free Real Updated H12-811 Questions & Answers Pass Your Exam Easily [Q216-Q233]

NO.216 In the VRP interface, use the command delete vrpcfg.zip to delete the file. You must empty the recycle bin to completely delete the file.

NO.217 Telnetlib is a module that implements the Telnet protocol that comes with Python.

NO.218 What is the value of TPID defined by IEEE802.1Q?

NO.219 By default, the root path cost of the root bridge in the STP protocol must be 0.

NO.220 The Priority field in the VLAN tag can identify the priority of the data frame. What is the range of this priority?

NO.221 If the Proto of a certain route information in the routing table is Direct, the priority of this route is set to 0.

NO.222 The number of VLANs that can be created using the commands “vlan batch 10 20” and “vlan batch 10 to 20” respectively is

NO.223 The administrator wants all hosts to be unable to access the Internet between 8:00-17:00 every day, so which ACL rule needs to be bound to the traffic-filter outbound in the GO/0/1 interface allocation?

NO.224 After the network administrator uses the TracertRoute function on the router device, in the data packet sent by the router, what is the value of the Protoco1 field in the IPv4 header?

NO.225 There are multiple route entries to the same destination network in the routing table. These routes are called:

NO.226 What kind of message does the DHCP server use to confirm that the host can use the IP address?

NO.227 In the network shown in the figure below, all routers run OSPF protocol, which device is ABR? (Multiple choice)

NO.228 What is the role of the command port trunk allow pass vlan all?

NO.229 Which of the following statement about the TTL field in the IP packet header is correct?

NO.230 The following statements about the election of active ports in link aggregation LACP mode. Which is correct?

NO.231 On the VRP platform, the default protocol priority of routes in the direct routing, static routing, RIP, OSPF area is:

NO.232 As shown in the figure, all four switches run STP, and various parameters adopt default values. If the G0/0/2 port of switch C is blocked and the configuration BPDU cannot be sent through this port, how long will it take for the blocked port in the network to enter the forwarding state?

NO.233 Which of the following descriptions are correct about the concept of IEV architecture? (Multiple choice)