[Apr 25, 2023] Pass Your 300-425 Dumps Free Latest Cisco Practice Tests [Q51-Q69]

Rate this post

[Apr 25, 2023] Pass Your 300-425 Dumps Free Latest Cisco Practice Tests

Get Top-Rated Cisco 300-425 Exam Dumps Now

The certification exam covers a wide range of topics related to designing enterprise wireless networks, including wireless network design principles, site surveys, RF planning, high-density wireless networks, and security. The exam is designed to test the candidate’s ability to design, implement, and troubleshoot wireless networks using Cisco technologies.

NO.51 Guest anchoring is configured for a newly created SSID for your company. It has been noticed that the mobility tunnels are not up, and that MPING fails from your foreign WLC to the anchor WLC. What is the reason that it is failing?

A rule is needed at the firewall to allow UDP port 16666 for communication to work.

A rule is needed at the firewall to allow UDP port 97 for communication to work.

A rule is needed at the firewall to allow TCP port 97 for communication to work.

A rule is needed at the firewall to allow TCP port 16666 for communication to work.

NO.52 An enterprise is using two wireless controllers to support the wireless network. The data centre is located in the head office Each controller has a corporate WLAN configured with the nameCopr-NET390595865WLC-1 and Copr-NET6837l638WLC-2. The APs are installed using a round-robin approach to load balance the traffic. What should be changed on the configuration to optimize roaming?

Move all access points to one controller and use the other as N+1 HA.

Use the same WLAN name for the corporate network on both controllers.

Place the access points per floor on the same controller.

NO.53 A company wants to replace its existing PBX system with a new VoIP System that will include wireless IP phones. The CIO has concerns about whether the company’s existing wireless network can support the new system. Which tool in Cisco Prime can help ensure that the current network will support the new phone system?

Location Readiness

Site Calibration

Map Editor

Voice Readiness

NO.54 Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.

When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

NO.55 An engineer is designing a new wireless network. The network needs to meet these requirements:

Which design approach should be taken?

5 GHz frequency band with channel bonding, to support 40 MHz channels

5 GHz frequency band without channel bonding, to support 20 MHz channels

5 GHz frequency band with channel bonding, to support 80 MHz channels.

2.4 GHz frequency band without channel bonding, to support 20 MHz channels

NO.56 An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?

the client that has the highest RF properties

the client that is used most by the company

the client that is used least by the company

the client with the worst RF characteristics

NO.57 A high-density wireless network is designed. Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?

Band Select

RRM

Cisco Centralized Key Management

load balancing

NO.58 Refer to the exhibit.

A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS. Which scenario explains the client roaming behavior?

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is moved from the original controller to the new controller.

Controllers do not exchange mobility control messages (over UDP port 16666) and the client database, entry is not moved from the original controller to the new controller.

Controllers exchange mobility control messages (over UDP port 16666) and a new client session is started with the new controller.

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is tunneled from the original controller to the new controller.

NO.59 A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3×3 MIMO. Which reason explains this behavior?

A redundant power supply is unavailable on the switch.

The switch is 802.3af capable.

The AP is getting power from a power injector.

The switch is PoE+ capable.

NO.60 A network engineer is working on a predictive WLAN design. The new wireless network must support access to internet, email, voice, and the inventory database To successfully support these services, which configuration must the engineer use for the signal strength levels and SNR on the planning tool?

signal strength of 67 dBm. 20-dB SNR and maximum 1 percent packet loss

signal strength of -67 dBm. 20-dB SNR. and maximum 5 percent packet loss

signal strength of -67 dBm. 25-dB SNR. and maximum 1 percent packet loss

signal strength of -70 dBm. 30-dB SNR. and maximum 10 percent packet loss

NO.61 A wireless network consultant must assess an existing wireless LAN controller. Which section must the consultant check before replacing the old APs with APs that are IEEE 802.11ac-capable?

number of AP licenses

controller PSU

throughput capacity

software version

NO.62 During a post-deployment site Survey, issues are found with non wi-Fi interference. What should the engineer use to identify the source of the Interference?

Network analysis module

Wireless intrusion prevention

Wireshark

Cisco spectrum expert

NO.63 An engineer is configuring a centralized set of controllers for separate facilities. Which two Cisco wireless architectures must be used to ensure flexible sizing of WLAN to VLAN mappings? (Choose two.)

interface group

mobility group

AP group

controller group

RF group

NO.64 Refer to the exhibit.

A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS. Which scenario explains the client roaming behavior?

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is moved from the original controller to the new controller.

Controllers do not exchange mobility control messages (over UDP port 16666) and the client database, entry is not moved from the original controller to the new conrtoller.

Controllers exchange mobility control messages (over UDP port 16666) and a new client session is started with the new controller.

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is tunneled from the original controller to the new controller.

NO.65 Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected?

rping

ping

eping

mping

NO.66 A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern?

Paint the access point to cover the LED from being noticeable.

Use enclosures to hide the wireless infrastructure in the surrounding environment.

Use AIR-AP-BRACKET-1 to allow for greater mounting locations

Deploy environmentally friendly cabling components to blend into the environment.

NO.67 Refer to the exhibit.

Which two statements about Cisco Prime Infrastructure are true? (Choose two.)

It presents the recommended number of APs for the selected coverage area based on the selections made.

Planning mode requires a special license in Cisco Prime Infrastructure.

It shows the map editor feature in Cisco Prime Infrastructure.

Controllers must be synchronized with Cisco Prime Infrastructure for planning mode to work.

It shows the planning mode feature in Cisco Prime Infrastructure.

NO.68 When conducting a site survey for real-time traffic over wireless, which two design capabilities of smartphones and tablets must be considered? (Choose two.)

no support for 802.11ac

higher data rates than laptops

fewer antennas than laptops

no support for 802.11r

lower data rates than laptops

NO.69 An enterprise is using the wireless network as the main network connection for corporate users and guests. To wireless network availability. Two Standalone controllers are installed in the head office. APs are connected to the controllers using a round-robin approach to load balance the traffic. After a power cut, the wireless clients disconnect while roaming. An engineer tried eping from the controller but faits.
Which protocol needs to be allowed between the networks that the controllers are installed?

IP Protocol 67

IP Protocol 77

IP Protocol 87

IP Protocol 97

The Cisco 300-425 certification exam is a valuable credential for individuals who are interested in pursuing a career in wireless networking. The exam covers a wide range of topics related to wireless LAN design, deployment, and security, and is designed to test the candidate’s knowledge and skills in applying these concepts to real-world scenarios. Passing this exam can lead to greater job opportunities and higher salaries, making it a worthwhile investment for anyone looking to advance their career in the wireless networking industry.

Passing Key To Getting 300-425 Certified Exam Engine PDF: https://www.actualcollection.com/300-425-exam-questions.html

Leave a comment Cancel reply