Check Real NACE NACE-CIP1-001 Exam Question for Free (2023) [Q17-Q37]

QUESTION 17
SSPC SP 1 identifies the use of:

QUESTION 18
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

QUESTION 19
Prior to the pre-job conference you notice that the Inspection and Test Plan does not require a hold point after surface preparation and coating application. In speaking with the owners’ representative in advance of the meeting you sense he/she does not understand the importance of the hold point.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

QUESTION 20
Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

QUESTION 21
When applying Thermal Spray Coatings the specification is most likely to refence:

QUESTION 22
An Inspector should change position when:

QUESTION 23
Check abrasive blast pressure with a

QUESTION 24
Owners hire NACE Inspectors’ with the expectation that:

QUESTION 25
Surface profile describes:

QUESTION 26
Dew point is the temperature at which

QUESTION 27
What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

QUESTION 28
You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

QUESTION 29
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

QUESTION 30
On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

QUESTION 31
When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

QUESTION 32
You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

QUESTION 33
If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a

QUESTION 34
An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

QUESTION 35
When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

QUESTION 36
Digital hygrometers

QUESTION 37
A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?