[Oct 02, 2023] 100% Real & Accurate NACE-CIP2-001 Questions with Free and Fast Updates [Q48-Q62]

QUESTION 48
When performing testing in accordance with ASTM D 2583 the inspector may observe:

QUESTION 49
An Inspection and Test Plan is required when:

QUESTION 50
It is always possible to see moisture on a steel substrate:

QUESTION 51
Inspection and Test Plans are provided to:

QUESTION 52
Coating surveys may include which steps?
Select All That Apply:

QUESTION 53
External coatings applied to buried pipelines are generally tested for:

QUESTION 54
Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

QUESTION 55
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

QUESTION 56
You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

QUESTION 57
The cost of qualified Coating Inspection is normally offset by:

QUESTION 58
The main reason dehumidification is used during coating operations is to

QUESTION 59
Inspector reports should always be copied to:

QUESTION 60
The HATE adhesion tester uses

QUESTION 61
Generally for safety considerations, waterjetting hose connections use

QUESTION 62
You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because: