Free 2024 NSE7_NST-7.2 Dumps 100 Pass Guarantee With Latest Demo [Q24-Q41]

Rate this post

Free 2024 NSE7_NST-7.2 Dumps 100 Pass Guarantee With Latest Demo

Prepare NSE7_NST-7.2 Question Answers Free Update With 100% Exam Passing Guarantee [2024]

QUESTION 24
Exhibit.

Refer to the exhibit, which shows the output of getrouterinfo bgp neighbors100.64.2.254.
What can you conclude from the output?

The BGP neighbor is advertising the 10.20.30.40/24 network to the local router.

The router ID of the neighbor is 100.64.2.254.

The BGP state of the two BGP participants is OpenConfirm.

The local router is adverting the 10.20.30.40/24 network to its BGP neighbor.

QUESTION 25
Refer to the exhibit.

FortiGate has already been configured with a firewall policy that allows all ICMP traffic to flow from port1 to port3.
Which changes must the administrator perform to ensure the server at 10.4.0.1/24 receives the echo reply from the laptop at 10.1.0.1/24?

Enable asymmetric routing under config system settings.

Modify the default gateway on thelaptop from 10.1.0.2 to 10.2.0.2

A firewall policy that allows all ICMP traffic from port3 to port1.

Change the configuration from strict RPF check mode to feasible RPF check mode

QUESTION 26
Refer to the exhibit, which shows the omitted output of a real-time OSPF debug

Which statement is false?

A password has been configured on the local OSPF router but is not shown in the output

The Hello packet is being sent from an OSPF router with ID 0.0.0.112.

The two FortiGate devices attempting adjacency are in area 0.0.0.0.

One FortiGate device is configured to require authentication, while the other is not

QUESTION 27
Exhibit.

Refer to the exhibit, which shows partial outputs from two routing debug commands.
Why is the port 2 default route not in the second command output?

The port2 interlace is disabled in the FortiGate configuration.

The port1 default route has a higher priority value than the default route using port2.

The port1default route has a lower priority value than the default route using port2.

The port1 default route has a lower distance than the default route using port2-

QUESTION 28

Refer to the exhibits, which show the configuration on FortiGate and partial session information for internet traffic from a user on the internal network.
If the priority on route ID _ were changed from 10 to 0, what would happen to traffic matching that user session?

The session would be deleted, and the client would need to start a new session.

The session would remain in the session table, but its trafficwould now egress from both port1.andport2.

The session would remain in the session table, and its traffic would egress from port2.

The session would remain in the session table, and itstraffic would egress from port1.

QUESTION 29
Consider the scenario where the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate. Which action will FortiGate take when using the default settingsfor SSL certificate inspection?

FortiGate closes the connection because this represents an invalid SSL/TLS configuration

FortiGate uses the 31 information from the Subject field in the server certificate.

FortiGate uses the first entry listed in the SAN field in the server certificate.

FortiGate uses the SNI from the user’s web browser.

QUESTION 30
Which two statements about application-layer test commands ate true? (Choose two.)

Some of them display statistics and configuration information about a feature or process.

Some of them display real-time application debugs.

Some of them display only output, after you run the diagnose debug console enable command.

Some of them can be used to restart an application.

QUESTION 31
Refer to the exhibit. whichcontains the output of diagnose vpn tunnellist.

Which command will capture ESP traffic for the VPN named DialUp_0?

diagnose sniffer packet any ‘host10.0.10.10’

diagnose sniffer packet any ‘ip proto 50’

diagnose sniffer packet any ‘esp and host 10*200.3.2’

diagnose sniffer packet any ‘port 4500’

QUESTION 32
Which statement is correct regarding LDAP authentication using the regular bind type?

The regular bind type goes through four steps to successfully authenticate a user.

The regular bind type cannot be used if users are authenticated using sAMAccountName.

The regular bind type is the easiest bind type to configure on FortiOS.

The regular bind typerequires a FortiGate super_adminaccount.

QUESTION 33
Refer to the exhibits.

An administrator is attempting to advertise the network configured on port3. However, FGT-A is not receiving the prefix.
Which two actions can the administrator take to fix this problem” (Choose two.)

Restart BGP using a soft reset, which forces both peers to exchange their complete BGP routing tables.

Manually add the BGP route on FGT-A.

Modify the prefix using the network command from 172.16.0.0/16 to 172.16.54.0724.

Use the set network-import-check disable command.

QUESTION 34
Which exchange lakes care of DoS protection in IKEv2?

IKE_Req_INIT

IKE_SA_INIT

IKE_Auth

Create_CHILD_SA

QUESTION 35
Refer to the exhibit, which shows a truncated output of a real-time LDAP debug.

What two conclusions can you draw from the output? (Choose two.)

The name of the configured LDAP server is Lab.

The user is authenticating using CN=John Smith.

FortiOS is able to locate the user in step 3 (Bind Request) of the LDAP authentication process.

FortiOS is performing the second step (Search Request) in the LDAP authentication process.

QUESTION 36
Exhibit.

Refer to the exhibit, which contains partial output from an IKE real-time debug.
The administrator does not have access to the remote gateway.
Based on the debug output, which configuration change can the administrator make to the local gateway to resolve the phase 1 negotiation error?

In the phase 1 proposal configuration, add AESCBC-SHA2 to the list of encryption algorithms.

In the phase 1 proposal configuration, add AES256-SHA256 to the list of encryption algorithms.

In the phase 1 proposal configuration, add AES128-SHA128 to the list of encryption algorithms.

In the phase 1 network configuration, set the IKE version to 2.

QUESTION 37
Which statement about IKE and IKE NAT-T is true?

IKE is used to encapsulate ESP traffic in some situations, and IKE NAT-T is used only when the local FortiGate is using NAT on the IPsec interface.

IKE is the standard implementation for IKEv1and IKE NAT-T is an extension added in IKEv2.

They each use their own IP protocol number.

They both use UDP as their transport protocol and the port number is configurable.

QUESTION 38
Refer to the exhibit, which shows a session table entry.

Which statement about FortiGate behavior relating to this session is true?

FortiGate forwarded this session without any inspection.

FortiGate is performing a security profile inspection using the CPU.

FortiGate redirected the client to the captive portal to authenticate, so that a correct policy match could be made.

FortiGate applied only IPS inspection to this session.

QUESTION 39
Refer to the exhibit, which shows two entries that were generated in the FSSO collector agent logs.

What three conclusions can you draw from these log entries? (Choose three.)

Remote registry is not running on the workstation.

The FortiGate firmware version is not compatible with that of the collector agent

DNS resolution is unable to resolve the workstation name.

The user’s status shows as “not verified” in the collector agent

A firewall is blocking traffic to port 139 and 445.

Dumps Real Fortinet NSE7_NST-7.2 Exam Questions [Updated 2024]: https://www.actualcollection.com/NSE7_NST-7.2-exam-questions.html

Leave a comment Cancel reply