Latest Jul-2022 JN0-103 Dumps PDF And Certification Training [Q22-Q42]

4/5 - (2 votes)

Latest Jul-2022 JN0-103 Dumps PDF And Certification Training

Check your preparation for Juniper JN0-103 On-Demand Exam

Q22. What statement is true about the orlonger route-filter match type?

All routes within the specified prefix that are longer than the given prefix are considered a match

All routes within the specified prefix that are longer or equal to the given prefix up to a defined acceptable prefix length are considered a match

All routes within the specified prefix that are longer or equal to the given prefix are considered a match

All routes within the specified prefix that are longer than the given prefix up to a defined acceptable prefix length are considered a match

Q23. Click the Exhibit button.

Referring to the exhibit, which logical interface is able to forward IP traffic?

ge-0/0/0

ge-0/0/2.0

ge-0/0/2

ge-0/0/1.0

Q24. Routing policies contain which two type of statements? (Choose two.)

and

from

default

then

Q25. Click the Exhibit button.

Referring to the exhibit, what happens to a packet that has a destination address of 172.17.0.1?

The packet is forwarded to the next hop defined in the default route.

The packet is silently discarded.

The packet is rejected and an ICMP network unreachable message is sent to the source address.

The packet is forwarded to the next hop of the management network.

Q26. A Junos device is configured with multiple routing protocols to the same destination prefix. By Default, which route will be active in the forwarding table?

A static route

An OSPF route

An IS-IS route

A BGP route

Q27. A Junos device is in a factory-default configuration and no host name is set.
What is used in place of a host name in this scenario?

router

amnesiac

Junos

user

Q28. Referring to the exhibit, what does the number inside the square brackets represent?

local preference

metric

protocol reference number

route preference

Q29. Exhibit:

Which statement is true about the command shown in the exhibit?

There needs to be a ; after top for the command to be accepted as a valid command.

Only top should be used, no other options are allowed on the same line.

The command shown in the exhibit would be accepted as a valid command.

If you replace top with up command, it becomes valid.

Q30. Referring to the exhibit,
***Exhibit is Missing***
Which statement is correct when traffic is received from 10.10.10.4?

The traffic is counted and accepted

The traffic is counted and rejected

The traffic is only rejected

The traffic is only accepted

Q31. What is an “X” release of the Junos OS?

a standard feature release

a special feature release

a feature velocity release

a feature beta release

Q32. Which two statements are true about the default behavior of Junos routing policies? (Choose two.)

Routing policies can export active and inactive routes.

Routing policies can export only active routes.

Routing policies control the flow of routing information going to and from the routing table.

Routing policies control the flow of routing information going to and from the forwarding table.

Q33. Which key could you use to auto-complete a command in the Junos CLI?

Delete

Ctrl+Z

Spacebar

Right Arrow

Q34. Referring to the exhibit,
***Exhibit is Missing***
What will be the result?

The device will boot in a multi-user mode at the configuration prompt

The device will boot in a Single-user mode at the operational prompt

The device will boot in a multi-user mode at the shell prompt

The device will boot in a Single-user mode at the shell prompt

Q35. When multiple users are editing the configuration on a Junos device, What is the default behavior when a user issues a commit command?

The user’s configuration changes are committed, other users configuration changes are still pending

The user’s configuration changes are committed, other users will be exited from the configuration mode

All valid configuration changes made by all users will take effect

The user will receive an error message disallowing a commit of the configuration

Q36. Which command is used to validate the syntax of a configuration without applying the configuration?

commit check

commit confirmed

commit synchronize

commit and-quit

Q37. A Junos device is in a factory-default configuration and no host name is set. What is used in place of a host name in this scenario?

amnesiac

router

Junos

user

Q38. Click the Exhibit Button.
[edit]
user@router# show firewall policer policer1 if-exceeding [
bandwidth-limit 1g; burst-size-limit 100k;
]
then discard;
You are asked to limit traffic on interface xe-0/0/3 to 1G using the policer shown in the exhibit. Which configuration would accomplish this task?

Option A

Option B

Option C

Option D

Q39. ***Exhibit is Missing***
Which command produced the output shown in the exhibit?

Show interfaces summary

Show interfaces filters

Show interfaces extensive

Show interfaces terse

Q40. Referring to the exhibit,

what happens when ping packets are sent to management interface address of the local router?

The ping packets are silently discarded

An ICMP unreachable message is returned

The Ping packets are accepted

An ICMP redirect message is returned

Q41. Referring to the exhibit,

Which next-hop interface will be used to reach the 10.21.14.16 destination?

ge-0/0/1.0

ge-0/0/0.0

ge-0/0/3.0

ge-0/0/2.0

Q42. Referring to the exhibit,

which command will cause this event message?

request system logout

request system commit

request system recover

request system halt

Loading …

Career Prospects

If you pass the Juniper JN0-103 exam with flying colors, you become entitled to the Juniper Networks Certified Associate certification. This certificate is known to be very beneficial, especially when it comes to career opportunities. The job roles that you can apply for after obtaining this certification include:

Senior System Engineer
Network Administrator
Network Architect
Network Engineer
System Engineer

After earning the Juniper Networks Certified Associate certification, you will also get the payroll benefits. According to PayScale, a Network Engineer can expect an average annual salary of $79,000, while the average annual income for a System Engineer is about $84,000.

Valid JN0-103 Dumps for Helping Passing Juniper Exam: https://www.actualcollection.com/JN0-103-exam-questions.html

Career Prospects

Leave a comment Cancel reply