[Q18-Q32] Best Quality 500-220 Exam Questions Cisco Test To Gain Brilliante Result!

Rate this post

Best Quality 500-220 Exam Questions Cisco Test To Gain Brilliante Result!

Preparations of 500-220 Exam 2024 Cisco Meraki Solutions Specialist Unlimited 74 Questions

Achieving the Cisco 500-220 certification demonstrates that an engineer has the skills and knowledge needed to design, implement, and manage Meraki solutions. Engineering Cisco Meraki Solutions certification is highly respected in the IT industry and is recognized by employers as a validation of the candidate’s expertise. Cisco Meraki solutions are widely used by organizations of all sizes, and engineers with this certification are in high demand. The Cisco 500-220 certification is an excellent way for IT professionals to advance their careers and demonstrate their expertise in Meraki solutions.

Q18. Which information is used to calculate whether a WAN link has high usage?

data under Security & SD WAN > Appliance Status > Uplink > Live Data

total historical throughput of an uplink

total number of devices that are actively passing traffic

value under Security & SD WAN > SD WAN & Traffic Shaping > Uplink Configuration

Q19. Refer to the exhibit.

What are the Loss and Average Latency statistics based on?

responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page

responses that the MX appliance receives on the connectivity-testing IP addresses on the Security & SD- WAN > Firewall page

responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security & SD-WAN > SD-WAN & Traffic Shaping page

responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page

Q20. What is the default frequency of SD-WAN probes sent between VPN peers in a Cisco Meraki MX SD-WAN deployment?

10 milliseconds

100 milliseconds

1 second

10 seconds

Q21. What are two organization permission types? (Choose two.)

Full

Read-only

Monitor-only

Write

Write-only

Q22. Air Marshal has contained a malicious SSID.
What are two effects on connectivity? (Choose two.)

Currently associated clients stay connected.

New clients can connect.

Currently associated clients are affected by restrictive traffic shaping rules.

New clients cannot connect.

Currently associated clients are disconnected.

Q23. Refer to the exhibit.

Which outcome occurs when logging is set to Enabled?

Outbound flows are sent to a configured syslog server if a syslog sender is configured for flows.

The hits counter within this section is now enabled.

This firewall rule is now enabled.

Inbound flows are sent to a configured syslog server if a syslog server configured for flows.

Q24. Refer to the exhibit.

This Dashboard organization uses Co-Termination licensing model.
What happens when an additional seven APs are claimed on this network without adding licenses?

All APs immediately stop functioning.

All network devices stop functioning in 30 days.

One AP Immediately stops functioning.

All APs stop functioning in 30 days.

Q25. Which two Systems Manager Live tools are available only for Apple Macs and Windows PCs and cannot be used on iOS or Android mobile devices? (Choose two.)

OS updates

Send notification

Selective wipe

Screenshot

Remote Desktop

Q26. Refer to the exhibit.

What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?

The MX appliance performs IDS/IPS for inter-VLAN traffic.

The MX appliance performs AMP for inter-VLAN traffic.

The MX appliance performs data encryption for inter-VLAN traffic.

The MX appliance performs content filtering for inter-VLAN traffic.

Q27. Refer to the exhibit.

Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?

WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the “Conf” performance class.

WebEx traffic will prefer WAN 1 as it is the primary uplink.

WebEx traffic will prefer WAN 2 as long as it is up.

WebEx traffic will be load-balanced between both active WAN links.

Q28. When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)

RADIUS for splash page settings

Firewall & traffic shaping

Captive Portal strength

Simultaneous logins

Controller disconnection behavior

Q29. Refer to the exhibit.

A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?

The concentrator gateway (10.128.124.62) is the next hop.

Not enough detail is available to determine the next hop.

The packet is stopped.

The Auto VPN peer “Store 1532 – appliance” is the next hop.

Q30. Refer to the exhibit.

What is the minimal Cisco Meraki Insight licensing requirement?

A single Meraki Insight license must be configured on network A to gain Web App Health visibility on network B.

A single Meraki Insight license must be configured on network B to gain Web App Health visibility on network B.

A single Meraki Insight license must be configured on network A, and a single license must be configured on network B, to gain Web App Health visibility on network B.

Two Meraki Insight licenses must be configured on network A to gain Web App Health visibility on network B.

Two Meraki Insight licenses must be configured on network A and a single license must be configured on network B, to gain Web App Health visibility on network B.

Q31. Which design requirement is met by implementing syslog versus SNMP?

when proactive alerts for critical events must be generated

when automation capabilities are needed

when organization-wide information must be collected

when information such as flows and client connectivity must be gathered

Q32. Which Meraki Dashboard menu section is accessed to enable Sentry enrollment on an SSID?

Wireless > Configure > Access Control

Wireless > Configure > Splash page

Wireless > Configure > Firewall & Traffic Shaping

Wireless > Configure > SSIDs

Cisco 500-220 certification exam covers a range of topics related to Cisco Meraki, including wireless, switching, security, and mobility. 500-220 exam is designed to test individuals’ abilities to apply these concepts to real-world scenarios, ensuring that they have the practical skills necessary to deploy and manage Cisco Meraki solutions in a variety of environments.

Focus on 500-220 All-in-One Exam Guide For Quick Preparation: https://www.actualcollection.com/500-220-exam-questions.html

Leave a comment Cancel reply