Best 300-610 Exam Dumps for the Preparation of Latest Exam Questions [Q63-Q84]

NEW QUESTION 63
An engineer must connect an existing Cisco Fabric Interconnect to an IP-based storage array. The connection be a channel made directly between the fabric interconnect expansion module and the storage array. The engineer must also consider that the environment is running FCoE for storage and uses QoS to prioritize traffic. Which port type should be used to meet these requirements?

Network

Uplink

Appliance

server

NEW QUESTION 64
Drag the requirements from the left onto the correct policy types on the right.

NEW QUESTION 65
Refer to the exhibit.

The Cisco Nexus Series Switch with hostname Nexus! is the default gateway for server A and server B Both servers must have reachability to the internet; however, server A internet traffic must pass through the firewall for deep packet inspection.
Also, the firewall must inspect any communication between server A and server B.
Which solution must be applied to separate the data plane path for server A and server B?

VLAN

VRF

VDC

VXLAN

NEW QUESTION 66
Which type of encoding is used on 8-Gbps links as compared to 10-Gbps links?

8-Gbps links use 64B/66B encoding, and 10-Gbps links use 8B/10B encoding.

8-Gbps links use 8B/10B encoding, and 10-Gbps links use 64B/66B encoding.

8-Gbps links and 10-Gbps links use 8B/10B encoding.

8-Gbps links and 10-Gbps links use 64B/66B encoding.

NEW QUESTION 67
The data center aggregation layer that uses IPv4 and IPv6 address space must act as a redundant Layer 3 gateway. The solution must support a minimum of 240 virtual groups for an interface. The data center aggregation layer hosts network devices from different vendors.
Which FHRP solution meets these requirements?

HSRPv1

VRRPV3

VRRPv1

HSRPv2

NEW QUESTION 68
An engineer is designing a data center that uses FCIP. How is QoS configured in this environment?

A separate DSCP value and CoPP must be configured for all FCIP traffic and another for all of the FCIP in the data connection.

A separate DSCP value must be configured for all FCIP VSAN traffic.

A separate DSCP value and priority queuing must be configured for all FCIP traffic.

Two separate DSCP values must be configured, one of all of the FCIP frames in the control TCP connection and another for all of the FCIP frames in the data connection.

NEW QUESTION 69
An architect is gathering technical requirements tor a large-scale data center with up to 3000 Ethernet ports and 70 ToR switches. The stakeholders agreed that it a ToR switch becomes compromised via its management plane, access to the production data plane must not be possible tram that switch. Which type of management network must the architect recommend in the design?

out-of-band dialup

in-band Ethernet

out-of-band Ethernet

in-band dialup

NEW QUESTION 70
Refer to the exhibit.

Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?

Secondary

Initial

Updating

Primary

NEW QUESTION 71
Which factor determines the choice of platform designing a Cisco HyperFlex infrastructure to support computer-aided design applications?

network speed

GPU support

storage capacity

processor count

NEW QUESTION 72
A network engineer is designing a Cisco Hyperflex infrastructure. The Infrastructure will be connected to an external SAN fiber channel array and must support Microsoft clustering.
Which storage connectivity method must be used to meet these requirements?

Internet Small Computer Systems Interface

Fibre Channel over Ethernet

raw device mapping

server message block

NEW QUESTION 73
An engineer is experiencing performance issues on a cisco UCS blade server. The B-series blade server contains four CPUs, most of which are idle. The engineer notices that the CPU is suffering from too many requests sent by the NIC. Additionally, the number of queues appears to be insufficient and only a single CPU is processing the network traffic. Which policy must be used to alleviate these issues?

Ethernet adapter

vNIC placement

LAN connectivity

Dynamic vNIC connection

NEW QUESTION 74
Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?

Cisco UCS Manager creates two separate fabric port channels.

Cisco UCS Manager creates a single fabric port channel.

The port channel is disabled until an administrator enables it manually.

Each uplink that connects an IOM is configured as a discrete link.

NEW QUESTION 75
A large financial institution hosts all customer data in a critical data center with a single physical location. Top management is concerned about the risk of a single-site failure, but budget is also an issue, so the network engineering team is working to implement a cost-effective redundancy strategy with a second data center. The new data center must use a three-tier design identical to the existing data center. Business requirements dictate that all data must always be accessible from anywhere in the world, even if a single site fails. The team purchased two Cisco Nexus 7700 Series Switches and four Catalyst 8000 Series Routers. Which action must the team take to accomplish the goal?

Implement HSRP with the Nexus 7700 Series devices to provide gateway redundancy to ensure seamless failover between the Nexus switches

Implement OTV with the Nexus 7700 Series devices to extend Layer 2 connectivity between the two data centers and provide disaster-recovery capabilities

Implement FabricPath on the Catalyst 8000 routers in both data centers to provide full redundancy in the event of a disaster

Implement NVGRE on the Catalyst 8000 routers to create a DCI communication channel between the data centers and provide Layer 2 extension capabilities

NEW QUESTION 76
A company must introduce a scalable network automation tool to deploy, configure, and manage thousands of network devices and servers. The company servers already have been security- hardened and must not have any additional software installed on them. The security policy mandates the use of a secure communication protocol that supports authentication and encryption for managing the servers.
Which two automation tools must be used to meet these requirements? (Choose two.)

Ansible

CFEngine

SaltStack

Chef

Puppet

NEW QUESTION 77
Drag the requirements from the left onto the correct policy types on the right.

NEW QUESTION 78
A company has several data centers with hundreds of Cisco UCS blade chassis. A network consultant plans to active Cisco Discovery Protocol to the servers to facilitate Layer 1 troubleshooting. For security reasons, the company wants to restrict the servers from sending different MAC addresses to the fabric interconnect after the MAC address from the first packet is learned. Which two policies be modified to support this design? (Choose two.)

Pin Group Policy

Network Control Policy

vNIC Policy

vNIC Template Policy

Ethernet Adapter

NEW QUESTION 79
Drag the appropriate from the left onto the current UDLD modes of operation on the right.

NEW QUESTION 80
An engineer needs to configure multiple network devices using Ansible Device passwords must meet these requirements:
be stored securely
not be visible as plaintext
be available to Ansible playbooks for executing scripts
Which solution must the engineer choose?

Encrypt a password variable file using Ansible Vault.

Store the passwords within a Git repository Secrets Manager

Encrypt passwords as Ansible environment variables

Encrypt the passwords within the Ansible inventory file.

NEW QUESTION 81
Where does Cisco UCS handle Fibre Channel traffic failover?

on a Cisco UCS Fabric Interconnect ASIC in Fibre Channel switching mode

on the host, by using multipathing software

in the hardware on the Cisco UCS VIC 12xx adapter or later

in the hardware on any Cisco UCS VIC adapter

NEW QUESTION 82
An engineer deploys LISP VM mobility. Which feature is configured on the interfaces that have VM mobility enabled?

IP redirects

flow control

proxy ARP

HSRP

NEW QUESTION 83
An engineer must configure a new maintenance policy that will apply to multiple Cisco UCS domains The policy must be available for use by service profiles and service profile templates created and managed n either Cisco UCS Manager or Cisco UCS Central Changes to this policy must be allowed only in Cisco UCS Central Which policy type must the engineer select to accomplish these goals?

hybrid policy

local policy

central policy

global pokey

NEW QUESTION 84
Which two configurations allow for routing traffic between two VDCs? (Choose two.)

Connect the VDCs to an external Layer 3 device.

Cross-connect the ports between the VDCs.

Create VRF-aware software infrastructure interfaces.

Create a policy map in the default VDC that routes traffic between the VDCs.

Create interfaces in the VDC that can be accessed by another VDC.

Leave a comment Cancel reply