Verified NACE-CIP1-001 dumps Q&As – 100% Pass from ActualCollection [Q42-Q65]

QUESTION 42
An inspectors personal log book should contain:

QUESTION 43
Passivation can best be described as:

QUESTION 44
You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

QUESTION 45
Osmotic blistering is most likely to occur as a result of

QUESTION 46
Which one of these elements is not necessary for corrosion to occur:

QUESTION 47
Removal of welds splatter is required:

QUESTION 48
Owners hire NACE Inspectors’ with the expectation that:

QUESTION 49
SSPC SP 1 identifies the use of:

QUESTION 50
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

QUESTION 51
ISO ST 3 is described as:

QUESTION 52
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

QUESTION 53
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

QUESTION 54
A NACE Coating Inspector is permitted to transport coating material when:

QUESTION 55
Digital hygrometers

QUESTION 56
You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

QUESTION 57
What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

QUESTION 58
The Inspector should record the serial numbers of inspection instruments:

QUESTION 59
You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

QUESTION 60
As a NACE Coating Inspector your responsibility with respect to safety is to:

QUESTION 61
Polymerization is the process of:

QUESTION 62
An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

QUESTION 63
ASTM Standards are applicable:

QUESTION 64
Check abrasive blast pressure close to the

QUESTION 65
When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to: