H12-261_V3.0-ENU Exam Dumps – PDF Questions and Testing Engine [Q284-Q298]

Rate this post

H12-261_V3.0-ENU Exam Dumps – PDF Questions and Testing Engine

H12-261_V3.0-ENU Dumps – The Sure Way To Pass Exam

NEW QUESTION 284
Which of the following descriptions are wrong about BGP load sharing? (Multiple Choice)

IBGP routes and EBGP routes arriving at the same destination on the public network can form load balancing.

If BGP load balancing is implemented, the local device needs to be configured with the peer next-hop-local command to change the next hop address to its own address when advertise router to the IBGP peer group.

The destination network segment is the same, and BGP routes with different sources can form load sharing.

The AS_Path attribute of the equal-cost route that forms load sharing must be different.

NEW QUESTION 285
Which of the following description on BCP properties is correct?

The AS number of the neighboring AS is arranged at the far right of the AS_Path list in the BGP routing entry.

When BGP Speaker advertises routes learned from EBCP peers to IBGP peers, it does not change the next hop attribute of the routing information.

Local_Pref is only valid between EBGP peers and is not advertised to third-party ASs.

A route can only have one community attribute value.

NEW QUESTION 286
In the following topology, R1 can access the Internet through R2 and R3. The EBGP connections are established between R1 and R2, R1 and R3. R2 and R3 belong to the same AS. The default route is advertised through BGP. The traffic that R1 is required to access the Internet is preferably R2. Which of the following practices can be achieved? (Multiple Choice)

R2 specifies that the peer R1 sets the MED attribute to 150 in the export direction.

R1 specifies that the peer R3 sets the MED attribute to 150 in the import direction.

R2 specifies that the peer R1 sets the local priority to 150 in the export direction.

R1 specifies that the peer R2 sets the local priority to 150 in the import direction.

NEW QUESTION 287
Which of the following operations can implement fast fault detection on multicast network? (Multiple choice)

Shorten the Holdtime of Join/Prune messages

Reduce the interval at which the interface sends Hello messages.

Establishing PIM BFD session between neighbors

Reduce the interval for sending Join/Prune messages.

NEW QUESTION 288
As shown in the figure, all routers run OSPF. Which of the following statements is correct?

R2 generates Router LSA in both area 1 and area

R2 only generates Router LSA in area 0

R2 forwards the Router LSA generated by R1 to R3

R2 forwards the Router LSA generated by R3 to R1

NEW QUESTION 289
By default, the switch configures the MAC address table to be empty. Host A connected to the switch sends the first unicast data frame. What operation will the switch perform after receiving the data frame?

The switch will discard the data frame

The switch forwards the data frame out of an interface according to the destination MAC address of the data frame.

The switch records the source MAC address of the data frame and floods the data frame.

The switch caches the data frame and waits for the destination host to send the data frame and then forward it.

NEW QUESTION 290
To configure AAA, you first need to define the XRADIUS RADIUS server as follows:
[Huawei] radius-server template EXAM
[Huawei-radius-EXAM] radius-serve shared-key cipher HUAwei123
[Huawei-radius-EXAM] radius-se authentication 10.7.66.66 1812
[Huawei-radius-EXAM] radius-se authorization 10.7.66.661812
[Huawei radius -EXAM] radius-server retransmit 27. 1813
[Huawei-radius-EXAM] radius-serv accounting 10

True

False

NEW QUESTION 291
The SWA and SWB are connected by two physical Ethernet links.
The SWA has the following interface configurations:
[SWA]interface GigabitEthernet 1/0/1
[SWA-GigabitEthernet 1/0/1] port link-type trunk
[SWA-GigabitEthernet 1/0/1] port trunk allow-pass vlan 1 0 100
[SWA]interface GigabitEthernet 1/0/2
131 / 144 The safer , easier way to help you pass any IT exams.
[SWA-GigabitEthernet 1/0/2] port link-type trunk
[SWA-GigabitEthernet 1/0/2] port trunk allow-pass vlan 1 10
These two links are aggregated
Assume that the configuration on the SMB is correct.
Which of the following statements are correct in view of this information? (Multiple Choice)

GigabitEthernet 1/0/1 and Gigabitethernet 1/0/2 can be added to the same LAG without changing the current configuration.

After the link aggregation is configured on the SWA and the SWB, if enabled MSTP, GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 will enter the Forwarding state in MSTP

GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 can be added to the same LAG only after GigabitEthernet 1/0/2 is configured. Change to the same as GigabitEthernet1/0/1

GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 cannot be added to the same LAG because the allowed VLANs are different.

NEW QUESTION 292
Which of the following BGP attributes are not required to be included in the Update message of BGP routing? (Multiple choice)

MED

Local-Preference

AS_PATH

Origin

NEW QUESTION 293
Which of the following description about the OSPF virtual link is true?

A virtual connection can be established in any area, and itself belongs to the area after it is established.

The virtual link uses the outbound interface P as the link address.

The virtual link can be used to solve the problem that area 0 is divided.

The cost of the virtual link is the optimal link.

NEW QUESTION 294
Which type of LSA cannot in the OSPF stub area? (Multiple Choice)

Type-7

Type-5

Type-4

Type-3

NEW QUESTION 295
There is an AS-path-filter, ip as-path-filter 1 permit ^100(_100)*(_400)*, which AS-PATH attribute cannot be matched by the As-path-filter?

100 400

100 400 400 400

100 200 900

100

NEW QUESTION 296
Which scenario can use AS-path -filter?

apply clause in Route-policy

If-match clause in Route-policy

Filter the route sent to the BGP neighbor according to the AS_PATH attribute carried in the route. For example, the command peer x.x.x.x as-path-filter export

Filter the route received to the BGP neighbor according to the AS_PATH attribute carried in the route. For example, the command peer x.x.x.x as-path-filter import

NEW QUESTION 297
The OSPFv3 Option field appears in all LSAs.

True

False

NEW QUESTION 298
There are many ways to establish a cluster for modular switches. What methods do Huawei modular switches support to establish a cluster? (Multiple Choice)

Established through the cluster card on the main control board

Established through the cluster daughter card on the interface board

Established through the business interface on the interface board

Established through the cluster card on the switching network board

Loading …

Pass Huawei H12-261_V3.0-ENU Exam Quickly With ActualCollection: https://www.actualcollection.com/H12-261_V3.0-ENU-exam-questions.html

Leave a comment Cancel reply